Taken on by me

 

It was not money alone that I contributed to this project. My history with the house and its wonderful but also very annoying issues had me make as clean a sweep as I could of issues as I went. As such I took on securing solutions for long time existing issues like the grey concrete floor.

 

Finding a window wall curtain solution

 

Historically the south window wall would frost up every night (1/8 of an inch or more) and melt down the inside every morning. This was a combination of the inside pool humidity, the single plate glass, and a lack of curtains.  Curtains would have helped. There were some old dusty curtains when we moved into the home in 1962. They were not in very good shape, so a plan was engaged to make new curtains. The result were curtains which could not fully be behind the wood structure of the window wall. The sun ate them up in a year and we deemed them a fire hazard and that was that for curtains. The moisture issues from my conversion to allow the inside pool to be a jacuzzi were handled by a hard cover limiting when its moisture could escape to only when we were indulging. As a fish and plant pool, a cover was never possible, and the care and cleaning were a disaster.

 

We needed to limit the solar wall glass to dual paned. Triple pane would have added another reflection layer and limited the gain we could get from the sun. The reason for the curve of the house was for the sun all day to have an area of the solar wall where the sun came straight in without and angle of reflection sideways. The only reflection in this area was simply from the angle of the sun in the sky. Yes, there was still gain from the other locations with sun, but those were diminished by east west angles in those locations.

So, I got the idea of an electric shade which would disappear during the day and then roll down to preserve heat gain when the sun went down. What I found was a company which took a commercial motor and placed it in an aluminum roller. I chose an exceptionally light tan fiberglass shade cloth which blended with the house stone very well.

 

 

79FirstDraftShadeSystem

In the upper right you can see the aluminum roller with sheets of fiberglass shade cloth and a reflective layer. The principle was great. Valance it up above the window wall and open and close with a commercial electric motor. Frankly, it looked horrendous. This was due to three separate layers coming down and sort of sealing at the floor level. However, it was the right idea. I also want to point you to the daylight darkness in the east master bedroom which had two windows in the north window wall but was isolated from the south where the limestone structure wrapped around the south front of the house for a bit.

 

This is another solution which eludes me except I do remember a reference to something done in John Denver’s house. This was a serious problem as the amount of glass in the south window wall could cause drafts as the cold rolled down after dark. Combined with the damage any curtains would have from daylight sun. It turned out that the first phase of the window wall was all done before I had a solution. The timing ended up working well. The refined design for the shades had a loop of shade with a weight pole within it to create a clean seal to the floor. When this material was lowered, one had a loop of material maybe 4” wide. Inside was a single layer of a reflective cloth to enhance what was gotten by the enclosed air pocket.

 

82FinalCurtainSystem2019

This was done in the unexpected second take of the window wall in 1985. More on this second take later. You can clearly see the loop with the weight to smoothly lower the electric shades. This picture was taken before I left to return to the east coast in 2019.The Moores were always nice upon the few visits we made back to their house. The timing of the final shade system worked well as its installation was done with the same clear redwood used to build the second window wall. It was valanced and we dropped tracks down at the edges of all the shades to seal the entire solar wall. They had made many improvements to my work during their stewardship. They placed all the shades under a single control and added inter-rafter south wall rafter lighting above the shades. There will be other shots of my second south wall and the completed shade tracks.

 


 

North Wall Credenza

 

A small but very annoying aspect of some of the house lighting was the lack of control to the box lights which were along every other balcony rafter downstairs from the fireplace to the west end. They were a 3-sided box with a bare bulb which shone back to the stone and highlighted it. The lights were attached where the balcony rafters came out of the stone pockets left for them when the rock work was done.  Like so many aspects of the house at night, you always wanted to turn them on at night. One pull chain at a time! I have always done minor electrical work. The work planned after the fin radiators came out provided the chance to take a single power run to allow all the box lights to turn on at once and dim them all as desired from a single switch. This was done as part of the planned enclosure around the heating/AC duct which ran along the floor on the berm wall. I built and ran conduit suitable to have different things in them to unify the box lights, provide electrical to each area of the balcony, and phone jacks. Conduit was used to allow future changes should they have been needed. Seems funny to think about wiring a house for phones now a days. But it is to be noted that several runs of conduit were used which would allow an ethernet wire backbone. Of course, today’s WI-FI is good enough that few houses have a wired ethernet backbone. It was so nice to walk to the fireplace area and simply turn on the box lights to any desired brightness. However, I must note that the old power to the balcony would not have been usable once the duct/credenza was completed and my work made the outlet access a bit more generous.

 

 

Trim out bathroom

 

 

83OldBath

 

The only reason I could think of for the tub to have been stuck in a dark corner requiring 360 degrees of curtain is perhaps to have a sewing or other work area in the room along the tower stairs wall. Fixing this with a slight bump to the master bedroom closet/bath entrance just made sense. The house has plenty of other spaces for projects.

 

 

This was a wonderful bathroom. It had tons of light from a very large skylight. I had the shower/tub moved from a dark corner to under the new skylight. When I was all done, the tub/shower was recessed into a slightly larger master bedroom walk-in closet. Additionally, the backup HVAC coming up through a corner of the bathroom, was enclosed.

 

Update the kitchen Cabinets

 

The kitchen had a beautiful wood counter I preserved and refinished it. The home-built plywood and pine cabinets were horrendous. They were deep enough that one frequently had to get onto one’s knees to work with the storage space. I made the kitchen cabinets more useful securing custom ones with nice doors and better function. The birch I chose brightened the place up quite a bit.

 

80Kitchen1982

 

The old cabinet doors were plywood, and the shelves were nailed into place. This kitchen was not a place where you wanted to hang cabinets on the walls and cover the rock. There were shelves just inside the utility room along curved wooden staircase wall well suited for pantry space. This meant the new cabinets continued to be used for dishes and cookware. There was an empty triangular sort of space between the stove and the refrigerator that I filled will one more cabinet.

 

84VeryPrimative

There really was not much to save here as we had to empty the entire house for the replacement of the radiant floor. So, the entire kitchen was emptied. All that was left was the stone and concrete as seen earlier. The color is off here as the floor really was grey at this time.

 

85CountersBackNewFloor

It was such a joy to start bringing the pieces of the house back together. The coffee pot could finally get off the floor. Here, the red is the new intentional red!

 

Let’s Deal

 

I went to a well-respected cabinet maker in Sun Prairie where I had lived for a bit and suggested that if they might give me a deal, I could advertise as people came through to view the home. They agreed.

 

86LetsDeal

Here the folks at Lessners were standing around the new corner cabinet I was adding to the kitchen.

 

 

87OnePair

One pair as it sat in the shop before they were delivered and installed.

 

88CornerCab

Here is the sign I displayed every chance I got per our agreement.

 

89KitchenDone

 

The kitchen was always the gathering place in this house as meals were prepared and small parties were held. I was very pleased with the function of the cabinets and how brightened the kitchen was. As you can see, even late afternoon, there was a shadow cast by the south stone wall on the east end of the house. The new floor color and the cabinets really brought a wonderful kitchen to a new level of enjoyment.

 

This is also a time to mention one of the subtle aspects to this house. As seen in the completed kitchen, one never worried about putting in a nail to hang something up where it would be useful. This was Herb’s ‘farmhouse’. Although, even when it was done, most of the wood surfaces were regular milling and nail holes just disappeared. The more refined surfaces were the final redwood solar wall and the restored balcony partitions.

 

 

Work Not Planned Yet

.

·      Insulating the berm down to frost depth

They did insulate the north berm wall. They stopped at ground level thus leaving the depth down to frost level without insulation. The square footage if you take the entire length of the north wall is substantial and is another reason the balcony space could be chillier. In the late 70s energy study this was about 20% of the heat lost. To do this would require excavating down to frost depth and insulating. I found a frost map but am unsure of the year. Madison has about a 55” frost depth.

·      Resolving rain coming into the house from the tower walls above the roof

My efforts to stop this leak never quite worked. I suspected the tower would have to come down to roof level and be capped and then rebuilt. This was not part of the very long list of “while we are at it”. That cost if needed would be independent of what I did in 1982 and 1985.

·      Stopping rain from coming down the chimney

A smoke shelf in the front of the fireplace would have eased the smoking which occurred with a new fire. The rain would have been helped if the chimney had ever had a real cap to keep rain out.

·      Reworking the studio into some nice extra space

This extra space was ok. It had plumbing and heat. It had had various uses over time, and I harken the Moores for their thoughtful addition to the property of a guest house and wood shop.

It had just been a stuccoed concrete block barn/art studio