Wing Tip Restoration

 

68WingTipDroop

Much to my dismay, preparations to fix the wing tips, roofing had to be removed from the path from the wing tip to the location the new support beam would tie into the new roof rafter infrastructure. It would be cantilevered over the southmost stonework on each end. By this time, the trailer bed had become uncomfortable, and I strived to find a place for my mattress inside for sleeping. Ironically, the only place stable in the rain was now in the old bedroom space near the doorway of the room at the top of the stairs. This had been my bedroom when we first moved into the house in 1962.

 

The wing tips, formed by the southern most points in the inner crescent, were a wonderful aspect of the circles within circles design. Sadly, the original build of these components was failing. The distant container is a typical gallon anti-freeze container. Unless we took care of this now, as we did a new insulated roof, it would continue to fail.

 

 

69WingFixes

 

As I mentioned earlier, this was a priority to get right after we had the new radiant floor in place and were still working on the house restructuring. There turned out to be a long metal plate in the facia structure which was a perfect place to weld the new support beam. By this time, we were quite used to jacking the roof and overhang. Here we see the point where the positioning was checked and then the beam welded on the east end.  A similar process completed the wing tip structure repair on the west end.

 

70ImbeddedBeams

The roof was built up around the beam to make it as invisible as possible

 

The New Roof

71RoofStripped

Finally, we were going to have an insulated roof (first time ever). I was very pleased to find that the roof itself was solid with little need to make any repairs to the base structure. The only places requiring any repairs were a couple spots in the tower roof. Once we were completely stripped, these were located and repaired. In the photo above, you will notice that a 2x2 furring strip was placed above the new cedar facia. This was for the tin roof edging which would guide drainage past the facia.

 

72FinallyInsulated

Above were some of the new 1.8” sheets of insulation being staged by the master bedroom on top of the shop where they could just be handed up as needed.

 

Ready Set Go

 

 

73Preped4NewRoof

 

We can see here the calm before the storm of work. As the final cleanup from the old roof is swept away roof sheeting is starting to be placed. The flashing has been sealed for all seven skylights and the tower roof is also all set.

 

75LayerOne

 

I just have always loved this photo. We went edge to edge on the first layer of insulation. This took the roof up to the top of the firring on the facia. Later, we would add the tin edging just before the final tar and pea gravel. The insulation was glued to the roof sheeting with the hot tar.

 

 

 

The second layer of insulation covered only the internal house area taking the R factor up to a very reasonable place. Again, the pieces were glued down with hot tar. Adding extra height in the center did not impact the lines of the roof when viewed from the property. Even the roofer, who vastly underestimated his bid, got into the circle motif as he did a donut on the lawn as he left in anger in his 4x4.

 

Scuppers

 

77Scuppersa

How nice that there were established ways to guide water off roofs and past the facia and not through it!

 

Done

 

78RoofFinally

Well, almost. The completion of the skylights had to wait for the delivery of the custom glass. This photo brings up the rain in the chimney. You can see the large clay pipe used to get a bit more draft through the chimney. You can also see it is indeed diverted up through stonework of the tower. Why did no one in the first 42 years (1947-1989) ever produce a chimney cap? It never even occurred to me!